When you are setting up a new player, it must have an SD card already inserted and you will need to add your player to B-Deploy (we will walk you through that process in this document). Please also review our SD card requirements. 

The following conditions MUST be met in order for this to work:

  • B-Dploy must be available on Zynchro
  • Player must have a working wired connection
  • Might not work on every Firmware 
  • Player must be reachable via local network

Also, please have both your player’s Serial Number and your local IP address on hand (if you do not have these both please do not proceed). You can get this information in Zynchro by location your player (By Map, By List, etc) and clicking on the Health tab, for your Serial Number, and then on the Network tab for the Local IP.


Go to Player Config > B-Deploy and click on the blue Add Player button. 

Image Placeholder

Input all fields. Choose Default Ethernet for Player config.

Image Placeholder


Once you see your player listed, you must now access it via local network. You can do this by opening a browser tab and inputting your local IP in the address bar. 


Image Placeholder


If a User Name and Password is requested, these generally are admin for both fields. 

Image Placeholder

Go to Control Tab and click on Reboot button below Reboot Player

Image Placeholder

If the process was successful, your player will continue it’s setup process and you should see it in Zynchro once it is done (this might take a few minutes). 


You can now publish your content to your player.